Advanced Settings; Exiting From The Setup Utility Program - Lenovo ThinkStation Hardware Maintenance Manual

2. Select Startup → Startup Sequence, and see the information displayed on the
3. Select the devices for the Primary Startup Sequence, the Automatic Startup
4. Select Exit from the Setup Utility menu and then Save Settings or Save and
If you have changed these settings and want to return to the default settings, select
Load Default Settings on the Exit menu.

Advanced settings

On some computer models, the Advanced settings menu includes a setting to
enable or disable HyperThreading. This feature works only with
HyperThreading-aware operating systems, such as Windows Vista. The default
setting for HyperThreading is Enabled. However, if you select Set Defaults and
are using an operating system other than Windows Vista, your computer
performance might be degraded. Therefore, you should always set
HyperThreading to Disabled unless you are sure your operating system supports
HyperThreading.

Exiting from the Setup Utility program

After you finish viewing or changing settings, press Esc to return to the Setup
Utility program menu (you might have to press Esc several times). If you want to
save the new settings, select Save Settings or Save and exit the Setup Utility.
Otherwise, your changes will not be saved.
54
Hardware Maintenance Manual
right side of the screen.
Sequence, and the Error Startup Sequence.
exit the Setup Utility.