Ford SUPER DUTY 2015 Owner's Manual page 54

1. Insert the key you want to program into
the ignition.
2. Switch the ignition on.
3. Access the main menu on the
information display controls. Press
SETUP using the information display
buttons until PRESS RESET TO
CREATE MYKEY is displayed.
4. Press and release the RESET button.
You will see HOLD RESET TO
CONFIRM MYKEY in the display.
5. Press and hold the RESET button for
two seconds until you see the message
MARK THIS AS RESTRICTED in the
display. Wait until you see KEY
RESTRICTED AT NEXT START in the
display.
If You Have a Type 2 Information
Display:
1. Insert the key you want to program into
the ignition.
2. Switch the ignition on.
3. Access the main menu on the
information display controls, and select
SETTINGS, then MYKEY by pressing
OK or the > button.
4. Press OK or the > button to select
CREATE A MYKEY.
5. When prompted, hold the OK button
until you see KEY RESTRICTED AT
NEXT START in the display. The key
will be restricted at the next start.
MyKey is successfully created. Make sure
you label it so you can distinguish it from
the admin keys.
You can also program configurable
settings for the key(s). Refer to
Programming/Changing Configurable
Settings.
Super Duty (), enUSA
MyKey
Programming/Changing
Configurable Settings
Use the information display to program or
change your configurable MyKey settings.
There are two types of information
displays, and their controls and messaging
vary. To determine which type of display
you have, you will need to reference
another chapter. See General
Information (page 81).
If You Have a Type 1 Information
Display:
1. Switch the ignition on using an admin
key.
2. Access the main menu on the
information display controls, and press
SETUP until RESET FOR MYKEY
SETTINGS displays.
3. Press and release the RESET button
to display MyKey setup menus.
4. Press the SETUP button to enter your
choice. Once you make a selection, the
next configurable setting will be
displayed.
5. Repeat Steps 3 and 4 until you are
done changing the configurable
settings.
If You Have a Type 2 Information
Display:
1. Switch the ignition on using an admin
key.
2. Access the main menu on the
information display controls, and select
SETTINGS, then MYKEY by pressing
OK or the > button.
3. Use the arrow buttons to get to a
configurable feature.
4. Press OK or > to make a selection.
51