Tire Change Procedure - Ford SUPER DUTY 2015 Owner's Manual

B
B
E162798
1. Attach the spare tire lock key (A) to the
jack handle (B).
E162799
2. Fully insert the jack handle (with one
extension) through the bumper hole
and into the guide tube. The key and
lock will engage with a slight push and
counterclockwise turn. You will feel
some resistance when you turn the jack
handle assembly.
3. Turn the handle counterclockwise and
lower the spare tire until you can slide
the tire rearward and the cable is slack.
4. Remove the retainer through the center
of the wheel. If your vehicle is equipped
with a tether, perform the following
steps.
Super Duty (), enUSA
Wheels and Tires
A
A
291
E162800
5. Lift the spare tire on end to access the
tether attachment.
6. Use the lug wrench to remove the lug
nut from the spare tire tether.
7. If not replacing the spare or flat tire to
the underbody storage area, raise the
wheel retainer up into the installed
position.
8. Use the attached fastener strap (on
the spare tire tether) to attach the
tether end to the winch retainer prior
to raising to the installed position.

Tire Change Procedure

WARNINGS
When one of the front wheels is off
the ground, the transmission alone
will not prevent the vehicle from
moving or slipping off the jack, even if the
transmission is in park (P).
To help prevent the vehicle from
moving when you change a tire, be
sure to place the transmission in park
(P), set the parking brake and block (in
both directions) the wheel that is
diagonally opposite (other side and end of
the vehicle) to the tire being changed.
Never get underneath a vehicle that
is supported only by a jack. If the
vehicle slips off the jack, you or
someone else could be seriously injured.