Table of Contents
Advertisement
an existing access point, and select
Copy to other
dest..
To change the priority order of access points within a group,
scroll to an access point and
priority.
Packet data access points
Select
Menu
Ctrl. panel
>
Destinations
Access
>
on the screen.
To edit a packet data access point, open one of the access
point groups, and select an access point marked with
Follow the instructions from your service provider.
Select from the following:
Connection name
— Define a name for the connection.
•
Data bearer
— You might not be able to edit the data
•
bearer once defined. Define a new access point if needed.
Access point name
— You obtain the access point name
•
from your service provider.
User name
— The user name may be needed to make a
•
data connection, and is usually provided by your service
provider.
Prompt password
— If you must enter the password
•
every time you log in to a server, or if you do not want to
save your password in the device, select Yes.
Password
— A password may be needed to make a data
•
connection and is usually provided by your service
provider.
© 2009 Nokia. All rights reserved.
Options
Organise
>
Options
Organise
>
Settings
and
Connection
>
point, and follow the instructions
Authentication
•
>
password encrypted or
encrypted when possible.
Homepage
•
Change
>
setting up, enter the web address or the address of the
multimedia message centre.
Use access point
•
want the device to ask for confirmation before the
connection using this access point is created, or
Automatically
>
destination using this access point automatically.
Select
Options
following:
.
Network type
•
transfer data to and from your device. The other settings
depend on the selected network type.
Phone IP address
•
of your device.
DNS addresses
•
and secondary DNS servers, if required by your service
provider. To obtain these addresses, contact your internet
service provider.
Proxy server address
•
server.
Proxy port number
•
server.
WLAN internet access points
Select
Menu
Destinations
— Select
Secure
to always send your
Normal
to send your password
— Depending on the access point you are
— Select
After confirmation
if you want the device to connect to the
Advanced settings
>
— Select the internet protocol type to
(for IPv4 only) — Enter the IP address
— Enter the IP addresses of the primary
— Enter the address of the proxy
— Enter the port number of the proxy
Ctrl. panel
Settings
>
>
Access
point, and follow the instructions
>
if you
and from the
and
Connection
>
61
Advertisement
Table of Contents
