Positioning Settings - Nokia E72 User Manual

Route guidance
Select Menu Applications
>
Navigation.
Start the route guidance outdoors. If started indoors, the GPS
receiver may not receive the necessary information from the
satellites.
Route guidance uses a rotating compass on the device
display. A red ball shows the direction to the destination, and
the approximate distance to it is shown inside the compass
ring.
Route guidance is designed to show the straightest route and
the shortest distance to the destination, measured in a
straight line. Any obstacles on the route, such as buildings
and natural obstacles, are ignored. Differences in altitude are
not taken into account when calculating the distance. Route
guidance is active only when you move.
To set your trip destination, select
destination and a landmark as the destination, or enter the
latitude and longitude coordinates.
To clear the destination set for your trip, select
navigation.
Retrieve position information
Select Menu Applications
>
Position.
In the position view, you can view the position information
of your current location. An estimate of the accuracy of the
location is displayed.
© 2009 Nokia. All rights reserved.
GPS GPS data and
> >
Options Set
>
Stop
GPS GPS data and
> >
To save your current location as a landmark, select
Save position. Landmarks are saved locations with more
information, and they can be used in other compatible
applications and transferred between compatible devices.
Trip meter
Select Menu Applications
>
distance.
The trip meter has limited accuracy, and rounding errors may
occur. Accuracy can also be affected by availability and quality
of GPS signals.
To turn trip distance calculation on or off, select
Start orStop. The calculated values remain on the display.
Use this feature outdoors to receive a better GPS signal.
To set the trip distance and time and average and maximum
speeds to zero, and to start a new calculation, select
Options > Reset. To set the trip meter and total time to zero,
select Restart.

Positioning settings

Select Menu Ctrl. panel
>
Positioning.
Positioning methods
Select from the following:
Integrated GPS — Use the integrated GPS receiver of your
•
device.
Options
GPS GPS data and
> >
Options
Settings and General
>
>
Trip
>
>
87