HP Compaq Elite 8300 Maintenance & Service Manual page 176

Table 10-1 Numeric Codes and Text Messages (continued)
Control panel message
1151-Serial Port A Address Conflict
Detected
1152-Serial Port B Address Conflict
Detected
1155-Serial Port Address Conflict Detected
1720-SMART Hard Drive Detects Imminent
Failure
1796-SATA Cabling Error
1797-SATA Drivelock is not supported in
RAID mode.
1801-Microcode Patch Error
168 Chapter 10 POST Error Messages
Description
Both external and internal serial ports are
assigned to COM1.
Both external and internal serial ports are
assigned to COM2.
Both external and internal serial ports are
assigned to same IRQ.
Hard drive is about to fail. (Some hard
drives have a hard drive firmware patch that
will fix an erroneous error message.)
One or more SATA devices are improperly
attached. For optimal performance, the
SATA 0 and SATA 1 connectors must be
used before SATA 2.
Drivelock is enabled on one or more SATA
hard drives, and they cannot be accessed
while the system is configured for RAID
mode.
Processor is not supported by ROM BIOS.
Recommended action
1. Clear CMOS. (See Appendix B,
Password Security and Resetting
CMOS on page 176.)
2. Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1. Clear CMOS. (See Appendix B,
Password Security and Resetting
CMOS on page 176.)
2. Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1. Clear CMOS. (See Appendix B,
Password Security and Resetting
CMOS on page 176.)
2. Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1. Determine if hard drive is giving correct
error message. Enter Computer Setup
and run the Drive Protection System
test under Storage > DPS Self-test.
2. Apply hard drive firmware patch
if applicable. (Available at
http://www.hp.com/support.)
3. Back up contents and replace hard
drive.
Ensure SATA connectors are used in
ascending order. For one device, use SATA
0. For two devices, use SATA 0 and SATA
1. For three devices, use SATA 0, SATA 1,
and SATA 2.
Either remove the Drivelocked SATA device
or disable the Drivelock feature. To disable
the Drivelock feature, enter Computer
Setup, change Storage > Storage
Options > SATA Emulation to IDE, and
select File > Save Changes and Exit.
Reenter Computer Setup and select
Security > Drivelock Security. For each
listed Drivelock-capable SATA device,
ensure Drivelock is Disabled. Lastly,
change Storage > Storage Options >
SATA Emulation back to RAID and select
File > Save Changes and Exit.
1. Upgrade BIOS to proper version.
2. Change the processor.