Front Bezel - HP Compaq Elite 8300 Maintenance & Service Manual

Front bezel

The front bezel is located on the front of the computer and is secured to the main system bracket with
eight Torx screws.
Replacement bezels include the webcam shutter and capacitive sensor board. On models that do not
include a webcam, you must remove the shutter and install the webcam insert (Webcam assembly
kit) into the slot in which the webcam would otherwise be installed.
To remove the front bezel:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
3. Remove the stand (see
4. Remove the lower panel (see
5. Remove the optical drive (see
6. Remove the metal plate (see
7. Remove the power supply (see
8. Remove the side panels (see
9. Remove the speakers (see
10. Remove the power button board (see
11. Lift the bracket from the bottom-left side of the computer.
Figure 7-73
100 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
Access panel on page
Stand on page
Lower panel on page
Replacing the optical disc drive on page
Metal plate on page
Power supply on page
Side panels on page
Speakers on page
Removing the bracket
Preparing to disassemble the computer on page
42).
44).
46).
47).
86).
84).
82).
Power button board on page
53).
97).
38).