Horizon Fitness ASCENT TRAINER AT1501 User Manual page 5

BOLT (C)
16 mm
Qty: 12
A SSEM BLY ST EP 2
HARDWARE BAG 2 CONTENTS:
BOLT (C)
16 mm
Qty: 12
ASSEMBLY STEP 2:
TOP HANDRAIL
ARC WASHERS (E)
BOLTS (C)
REAR
UPRIGHT
BASE RAIL
BRACKET CAPS
A Open HARDWARE BAG 2.
B Attach the REAR UPRIGHTS to the BASE FRAME using 4 BOLTS (C), 4 WASHERS (D), 4 BASE RAIL CAPS and
2 AXLES.
NOTE: Assemble the TOP HANDRAILS so they are parallel to the floor. Do not assemble with the TOP
HANDRAIL resting on the floor.
NOTE: Assemble the REAR UPRIGHTS so they curve toward the MAIN FRAME as illustrated.
C Partially thread the TOP HANDRAILS to the REAR UPRIGHTS using 8 BOLTS (C) and 8 ARC WASHERS (E).

AT1501_Rev.2.6.indd 8-9
WASHER (D) ARC WASHER (E)
25 mm 17 mm
Qty: 4 Side View Qty: 8
WASHER (D) ARC WASHER (E)
25 mm 17 mm
Qty: 4 Side View Qty: 8
MAIN FRAME
ARC WASHERS (E)
BOLTS (C)
BASE RAIL
BASE RAIL
AXLE
WASHERS (D)
AXLE
BASE RAIL
WASHERS (D) BOLTS (C) BRACKET CAPS
ASSEMBLY STEP 
HARDWARE BAG  CONTENTS:
AXLE
Qty: 2
ASSEMBLY STEP :
TOP HANDRAIL
BOLTS (C)
A Open HARDWARE BAG 3.
B Attach each TOP HAND RAIL to the INCLINE ARM using 4 BOLTS (F) and 4 NUTS (G). To make assembly
easier, lightly tighten all four bolts to begin, then tighten firmly after all bolts have been started.
NOTE: The INCLINE ARM extends from the front of the REAR MAST COVER.
NOTE: Tighten all hardware from Assembly Step 2.
BOLT (F) NUT (G)
25 mm 8 mm
Qty: 4 Qty: 4
BOLT (F) NUT (G)
25 mm 8 mm
Qty: 4 Qty: 4
INCLINE ARM
BOLTS (F)
NUTS (G)
TOP H

7/31/08 12:43:22 PM