Horizon Fitness ASCENT TRAINER AT1501 User Manual page 8

A SSEM BLY ST EP 
HARDWARE BAG  CONTENTS:
BOLT (C)
16 mm
Qty: 6
ASSEMBLY STEP :
BOLT (C)
WASHER (D)
SWING CAP
PACKAGING PLASTIC
A Lay waste packaging plastic over the BASE RAIL. This will prevent the PEDAL ARM assembly from scratching
the ascent trainer's paint.
B Open HARDWARE BAG 8.
C Place 1 WAVY WASHER (J) onto CRANK.
D Attach the right PEDAL ARM of the assembly to the right CRANK using 1 WASHER (D) and 1 BOLT (C).
E Attach right SWING ARM to TOP HANDRAIL using 2 SWING CAPS, 2 BOLTS (C), 1 SHAFT and 2 WASHERS (D).
F Attach the CRANK CAP to the CRANK
G Repeat on opposite side.
1
AT1501_Rev.2.6.indd 14-15
WASHER (D) WAVY WASHER (J) AXLE
25 mm 29 mm Qty: 2
Qty: 6 Qty: 2
TOP HANDRAIL
CRANK
BOLT (C)
WASHER (D)
CRANK CAP
WAVY WASHER (J)
AXLE
BOLT (C)
SWING CAP
WASHER (D)
RIGHT SWING ARM
PEDAL ARM
LINK ARM
ASSEMBLY STEP 
HARDWARE BAG  CONTENTS:
BOLT (N) WASHER (L)
45 mm 18 mm
Qty: 2 Qty: 2
ASSEMBLY STEP :
A Open HARDWARE BAG 9.
B Slide 1 ROD BEARING SHAFT into the joint end of right LINK ARM.
C Fit 1 SPACER on each side of each ROD BEARING SHAFT after the ROD BEARING SHAFTS are in LINK ARM.
D Attach right LINK ARM to the right LOWER HANDLEBAR using 1 BOLT (N), 1 WASHER (L) and 1 NUT (G).
E
Repeat on opposite side.
ROD BEARING SPACER NUT (G)
SHAFT Qty: 4 8 mm
Qty: 2 Qty: 2
LOWER
HANDLEBAR
WASHER (L)
NUT (G)
BOLT (N)
SPACER
ROD BEARING
SPACER
SHAFT
LINK ARM
15
7/31/08 12:43:49 PM