Selecting A Single Picture And Printing It - Leica D-LUX 5 Instructions Manual

Connect the camera to a printer via the USB connection cable A
(supplied).
•
When the camera is connected to the printer, the cable disconnect prohibit icon [å]
appears. Do not disconnect the USB cable while [å] is displayed.
Press 3/4 to select [PictBridge(PTP)], and then
press [MENU/SET].
Note
•
Do not use any other USB connection cables except the supplied one.
Use of cables other than the supplied USB connection cable may cause malfunction.
•
Before inserting or removing a card, turn the camera off, and disconnect the USB connection
cable.
•
You cannot switch between the internal memory and the card while the camera is connected to
the printer. Disconnect the USB connection cable, insert (or remove) the card and then connect
the USB connection cable to the printer again.
•
Motion pictures cannot be printed out.
Press 2/1 to select the picture and then press
[MENU/SET].
•
The message disappears in about 2 seconds.
Press 3 to select [PRINT START] and then press
[MENU/SET].
•
Refer to P192
print the pictures.
•
Press [MENU/SET] to cancel printing halfway.
•
Disconnect the USB connection cable after printing.
Connecting to other equipment

Selecting a single picture and printing it

for the items which can be set before starting to
- 190 -
USB MODE
PLEASE SELECT
THE USB MODE
PictBridge(PTP)
PC
MENU
SELECT SET
PictBridge
100-0001
100-0001
PLEASE SELECT
THE PICTURE TO PRINT
MULTI PRINT
MENU
SELECT PRINT
SINGLE SELECT
PRINT START
PRINT WITH DATE
OFF
NUM. OF PRINTS
1
PAPER SIZE
PAGE LAYOUT
CANCEL SELECT MENU
SET