Kenmore 592-89107 Use & Care Manual page 7

Closet installation - Dryer only
14" max.
*
(35.6 cm)
18" min. *
(45.72 cm)
1" * 32 9 ⁄ " 5" **
16
(2.5 cm) (82.65 cm) (12.7 cm)
A
A
A. Side view - closet or confined area
B. Closet door with vents
* Required spacing
** For side or bottom venting, 2" (5.1 cm) spacing is allowed.
Recessed or closet installation - Dryer on pedestal
1" 27"
(2.5 cm) (68.6 cm)
A
A
A. Recessed area
B. Side view - closet or confined area
* Required spacing
** For side or bottom venting, 2" (5.1 cm) spacing is allowed.
Installation spacing for cabinet installation
■ For cabinet installation, with a door, minimum ventilation
openings in the top of the cabinet are required.
7" (17.8 cm) 7"
*
5"
**
(12.7 cm)
* Required spacing
** For side or bottom venting, 2" (5.1 cm) spacing is allowed.
Kenmore_Dryer-Good-02687A-01_EN.indd 7
3"
*
(7.6 cm)
48 In.
2 *
(310 cm 2 )
24 In. 2 *
(155 cm )
2
3" *
(7.6 cm)
B
B
14" max. *
(35.6 cm)
18" min. *
(45.72 cm)
1"
1" 32 ⁄ " 5"
* 9 **
(2.5 cm)
16
(2.5 cm) (82.65 cm) (12.7 cm)
B
B
(17.8 cm)
*
(22.9 cm)
32 ⁄ " 1" 1" 27" 1"
9 *
16
(82.65 cm) (2.5 cm) (2.5 cm) (68.6 cm) (2.5 cm)
Recommended installation spacing for recessed or closet
installation, with stacked washer and dryer
The dimensions shown are for the recommended spacing.
48 In.
2 *
(310 cm 2 )
24 In.
2 *
(155 cm 2 )
* Required spacing
5½"
**
(14 cm)
* Required spacing
** For venting out the side, 2" (5.1 cm) spacing is allowed.
Mobile home - additional installation requirements
The installation of the Dryer in mobile homes must conform to
the Manufactured Home Construction and Safety Standard Title
24 CFR, Part 32-80 {formerly the Federal Standard for Mobile
Home Construction and Safety, Title 24, HUD (Part 280), 1975}
for the United States) or CSA Standards Z240 (for Canada).
When installing a Dryer in a mobile home, provisions for
anchoring the Dryer to the floor must be made. Locate an area
that has adequate fresh air.
A minimum of 72 in² (183 cm²) of unobstructed space is
required.
All mobile home installations must be exhausted to the outside
with the exhaust duct termination securely fastened to the
mobile home structure, using materials that will not support
combustion.
9" The exhaust duct may not terminate underneath the mobile
*
home.
See Exhausting section for more information.
Mobile home installations require:
■ Metal exhaust system hardware, which is available for
purchase from your local Sears store or Sears Service
Center.
■ Special provisions must be made in mobile homes to
introduce outside air into the dryer. The opening (such as a
nearby window) should be at least twice as large as the dryer
exhaust opening.
3" * (7.6 cm)
3" * (7.6 cm)
1" (2.5 cm)
*
6" (15.2 cm)
*
76"
(193 cm)
1" 1"
(2.5 cm) (2.5 cm)
27"
(68.6 cm)
2009-07-02 ¿ÀÈÄ 3:21:15
7