Multicode Troubleshooting; Troubleshooting Multicode Expression Programming; Troubleshooting Multicode Mode Scanning And Decoding - Motorola Symbol DS6878 Product Reference Manual

Multicode Troubleshooting

Troubleshooting Multicode Expression Programming

Use the following suggestions if encountering problems programming a multicode expression:
•
Ensure the expression is valid. Invalid expressions are rejected during programming. When an expression is
rejected the previous expression remains intact. If after programming the expression the digital scanner can
still decode any bar code, the expression was possibly rejected.
•
When programming the multicode expression via parameter bar code, the digital scanner generates beeps. If
any of the following beeps do not sound during programming, an error occurred (see
and Table 2-2 on page 2-3
• Scanning the
• Scanning each value of the expression produces a two-tone (same pitch) beep.
• Scanning the
•
Check the expression for syntax errors.
•
Try programming a simple expression to ensure the syntax is correct. See
Expressions.
•
Review Defining Multicode Expression Notes on page 5-26

Troubleshooting Multicode Mode Scanning and Decoding

Use the following suggestions if encountering problems using multicode mode:
•
If the digital scanner appears to decode any single bar code instead of the intended multiple bar codes,
ensure you enabled
multicode mode.
•
When specifying
• Coordinates are within range the 0-100 decimal (or 0x00 - 0x64 hexadecimal).
• Top, Left is above Bottom, Right. Top, Left is 0,0 (0x00, 0x00 hexadecimal), and Bottom, Right is 100,100
(0x64, 0x64 hexadecimal).
• Regions for two or more bar codes do not overlap.
•
When specifying
code without using multicode. If it does not decode try enabling the bar code type. See
Symbologies.
•
Experiment with simpler expressions, then add to it until you discover the source of the error. For example try
the simplest expression (see
single bar code. If so, extend the expression by adding a second bar code, specifying a region, or specifying
the code type. Verify that the digital scanner can decode this new expression. Continue adding to the
expression until it fails to decode as expected, indicating the source of the error.
•
Review Defining Multicode Expression Notes on page 5-26
User Preferences & Miscellaneous Digital Scanner Options 5 - 33
for error indicators):
bar code produces a two-tone (same pitch) beep.
Multicode Expression
bar code produces a four-tone (high-low-high-low) beep.
End Of Message
Multicode Mode on page
, ensure:
Region
ensure the digital scanner supports the code type. Try decoding a single bar
Code Type
Examples of Simple Multicode
for additional hints.
5-24. Programming the multicode expression does not enable
Expressions) and make sure you can scan a
for additional hints.
Table 2-1 on page 2-1
Examples of Simple Multicode
Chapter 14,