Important Note; Fcc Caution; Approved Antennas - Sierra Wireless AirLink MP User Manual

AirLink MP User Guide
56
The Main RF Main RF antenna must be mounted such that there is a separation
distance of at least 20 cm (8 inches) between the Main RF antenna and the body
of the user or any nearby persons.
For the MP modem, the maximum gain for the AP antenna must not exceed 3
dBi, and the AP antenna must be professionally installed with a separation
distance of at least 20 cm away from the Main RF antenna, per FCC Part 15
requirements.
Note: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.

Important Note

To comply with FCC RF exposure compliance requirements, the antenna used for
the WiFi transmitter must be installed to provide a separation distance of at least
20 cm from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter."

FCC Caution

Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.

Approved antennas

The WiFi antennas approved for use with this device must be of either a PCB
omni antenna with a gain of no more than +2 dBi, or a dipole antenna with a gain
of no more than +5dBi. No other antennas are approved for use with this device."
2130795