How To Replace The Brushes - Hoover U4359 Owner's Manual

How to replace the brushes

(Brushes - HOOVER part No. 48445001)
Disconnect cleaner from electrical outlet.
lowing directions given on preceding pages.
2. Turn end plates of agitator in
opposite directions until one end
plate comes off.
4. Remove opposite end plate
and shaft by pulling straight out.
Pry out remaining end section.
6. To reassemble, reverse proce-
dure. Replace the last end sec-
tion removed, then end plate and
shaft. Replace remaining end sec-
tion and end plate. Be sure end
sections are assembled with loca-
tor lined up with slot in agitator.
3. Then pry out end section as
shown.
5. Remove brushes by pulling them
from agitator. Use pliers if neces-
sary. Slide new brushes into chan-
nels. Push them in as far as possi-
ble.
END SECTION
7. Should you accidentally dis-
place the bearing during disas-
sembly, reassemble as shown.