How to replace the brushes
Disconnect the cleaner from electrical outlet.
1. To replace
worn
brushes,
remove
bottom
plate,
belt and agitator,
following
directions
given
on preceding
pages.
END
SECTI!
7
2. Turn end plates of agitator in
opposite
directions
to loosen.
END PLATE
3. Continue
turning
until one end
comes off exposing
the end section.
Then, pry out end section
exposing
the shaft.
END
LY
4. Gently tap the end of the shaft
with
hammer
to loosen opposite
end.
5. Pull shaft and end assembly from
agitator.
6. Remove
brushes
by pulling
them
from
agitator.
Slide
new brushes
into channels.
Push them in as far
as possible.
7. To reassemble,
replace shaft and
end assembly
lining up the Iocator
with the slot in the agitator.
Press
into place. Place remaining end sec-
tion over the shaft end, lining up the
Iocator and slot. Press into place.
Screw end plate on and tighten.
17