Ifyouhaveaproblem; Maintenance Authorized Service - Hoover U4359 Owner's Manual

If you have a problem
This appliance was inspected thoroughly and was in good operating con-
dition when it was shipped from the factory. If a minor problem devel-
ops, it usually can be remedied quite easily when the cause is identified.
Accordingly, this check list is provided for your convenience.
Problem Possible cause
Cleaner
won't
2. No voltage in wall plug.
run
3. Blown fuse/tripped
breaker.
Cleaner 1. Broken or worn belt
won't
2. Agitator brushes worn.
pick up 3. Bag full.
4. Incorrect carpet adjust-
ment lever setting.
1. Incorrect carpet adjust-
Cleaner
hard ment lever setting.
to push
2. Belt on incorrectly.
If the problem persists, check the Yellow Pages of your telephone
book under "Vacuum Cleaners - Household" for your nearest Hoover
Factory Service Center or Authorized Warranty Service Dealer where
approved HOOVER service and genuine HOOVER replacement parts
may be obtained. The warranty provided with this product has a listing
of the Hoover Factory Service Centers. If you are unable to obtain the in-
formation you need from the Yellow Pages, contact a Hoover Factory
Service Center to find your nearest Authorized Warranty Service Dealer.
For service under warranty, follow the instructions in the Warranty pro-
vided with this product.
D not send your cleaner to The Hoover Company in North Canton for
O
service as this will only result in delay.
Always identify your cleaner by model number when requesting informa-
tion or ordering replacement parts. (The model number appears on the
bottom of the cleaner.)
If further assistance is needed, contact The Hoover Company Con-
sumer Affairs Department, North Canton, Ohio 44720,216-499-9200.
Possible solution
1. Plug unit in firmly.
2. Check fuse or breaker.
3. Replace fuse/reset
b r e a k e r .
1. Replace belt.
2. Replace brushes.
3. Change throw away
bag.
4. Set carpet adjustment
lever for type carpet
being cleaned,
1. Set carpet adjustment
lever for type carpet
being cleaned.
2. Position belt correctly
(See page 19, #5).