Precautions For Installation - Panasonic AW-RP120G Operating Instructions Manual

Precautions for installation

In addition to the safety precautions given in "Read this first!", also observe the following instructions.
Be sure to ask your dealer to perform the installation and connection work for the unit.
Connecting a power supply
z Insert the DC plug for the external DC power supply all the way in
z
until it locks into place.
RE M OT E
LC D CO NT RA ST
SI GN AL GN
z When the unit will not be used for a long time, turn off the power
z
switch and remove the DC plug for the external DC power supply to
save power.
Example of embedding the unit in a desktop
When you will use the unit embedded in a desktop, refer to the following procedure.
1.
Make mount angles suitable for the installation location.
<Mount angle example>
z Desk mounting side (unit: mm (inch))
z
160 (0000)
z Unit mounting side
z
210 (0000)
140 (0000)
Ø3.5 (0000)
(Unit mounting hole)
2.
Attach the mount angles to the sides of the unit with
four M3 screws.
Note
z For details on the dimensions for attaching mount angles to the
z
unit, refer to "Appearance" (page 11).
10
PO W ER
DC plug
ON
IN
12 V
D
25 (0000)
Ø5 (0000)
(Desk mounting holes)
21
1.2 (0000)
(0000)
35
(0000)
Unit
M3 screws
Mount angle
Do not allow any foreign objects to enter inside the unit
z Allowing water, metal items, food or drink, or other foreign objects to
z
enter inside the unit may cause a fire or electric shock.
Installation location
z This unit is designed for indoor use only.
z
z Install and use the unit in a stable location.
z
z Avoid installing the unit where it will be exposed to direct sunlight.
z
z Installing the unit in a location with a lot of humidity, dust, or vibration
z
may result in a failure.
3.
Insert the unit into the desktop hole and then fix it in
place with four screws
30
(0000)
z Provide screws that match the size of the desktop mounting holes
(e.g. Ø5 mm (00
4.
If necessary, make and attach a panel to cover the rest
of desktop hole.
inches)).
Panel to cover hole