If You Have A Problem - Hoover SPIRIT Spirit Vacuum Cleaner Owner's Manual

If you have a problem

This appliance was inspected thoroughly and was in good operating con-
dition when it was shipped from the factory. If a minor problem develops,
it usually can be remedied quite easily when the cause is identified. Ac-
cordingly, this check list is provided for your convenience.
Problem Possible cause
Cleaner 1. Not firmly plugged in.
won't 2. No voltage in wall plug.
run 3. Blown fuse/tripped
breaker.
Cleaner
1. Bag full.
won't 2. Bag not opening.
pick up 3. Obstruction in nozzle,
hose or attachments.
4. Suction regulator
improperly set.
5. Secondary filter dirty.
Nozzle 1. Nozzle brush worn.
won't 2. Litter picker worn
pick up (some models).
3. Nozzle set for edge
If the problem persists, check the Yellow Pages of your telephone book
under "Vacuum Cleaners - Household" for your nearest Hoover Factory
Service Center or Authorized Warranty Service Dealer where approved
HOOVER service and genuine HOOVER replacement parts may be ob-
tained. The warranty provided with this product has a listing of the
Hoover Factory Service Centers. If you are unable to obtain the informa-
tion you need from the Yellow Pages, contact a Hoover Factory Service
Center to find your nearest Authorized Warranty Service Dealer. For
service under warranty, follow the instructions in the Warranty provided
with this product.
Do not send your cleaner to The Hoover Company in North Canton for
service as this will only result in delay.
Always identify your cleaner by model number when requesting informa-
tion or ordering replacement parts. (The model number appears on the
bottom of the cleaner.)
If further assistance is needed, contact The Hoover Company Con-
sumer Affairs Department, North Canton, Ohio 44720,216-499-9266.
17
Possible solution
1. Plug unit in firmly.
2. Check fuse or breaker.
3. Replace fuse/reset
breaker.
1. Change throw away bag.
2. Open bag by pulling folds.
3. Remove obstruction.
4. Set suction regulator
properly.
5. Clean or replace filter.
2. Replace litter picker.
3. Adjust dial on nozzle.