Power Nozzle; Edge Cleaning; Handle Positions - Hoover Power Nozzle Owner's Manual

Push plug on power nozzle cord
completely into cord receptacle
l
underneath hand grip.
Always disconnect cleaner from elec-
trical outlet before attaching or
removing power nozzle plug.
To reduce the risk of electric shock, this
appliance has a polarized plug (one
blade is wider than the other). This plug
will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install
the proper outlet. Do not change the
plug in any way.

Power nozzle

The power nozzle adjusts automatically
for cleaning hard surface floors and vari-
It is not recom-
ous heights of carpets.
mended for very irregular surfaces
such as brick, slate, and certain par-
quet floors unless it is unplugged
from the cleaner.
This will stop the agi-
tator from rotating. If desired, a special
wall/floor brush (shown in "Cleaning
tools" section) can be purchased for this
task, if it is not included with your model.
. For cleaners with plastic wands,
squeeze tabs on separate cord clip
together while pressing cord into small
slot (E).
Snap one cord clip (F) onto each exten-
placing
sion wand. Adjust cord,
excess between nozzle and bottom
cord clip.
After assembling cleaner, plug
cord into electrical outlet. Turn
cleaner on by depressing ON-OFF
pedal (A). To turn cleaner off, depress
pedal again.

Handle positions

q
The handle has two positions when
used with the power nozzle:
upright and operating.
To lower handle to operating position,
place your foot on the power nozzle and
pull handle back.
a
For cleaners with metal wands,
wands, placing excess cord between
nozzle and bottom cord clip.
Note: On models with wand storage
clip,
the bottom cord clip is on the wand
storage clip.
q
On models without cord rewind
release cord by rotating
pedal,
cord hook (6) inward before depress-
ing ON-OFF pedal (A).

Edge cleaning

q
, Brushed edge cleaning is provid-
ed on both sides of the nozzle to
remove embedded dirt in carpet near
baseboards and furniture. Guide either
side of nozzle parallel to edge of carpet
or furniture.