Table of Contents
Advertisement
11
• Fit the rear bumper onto the rear end of the frame.
12
Bottom View
• While holding the rear bumper in place, turn the frame
on its side.
• Insert two
1
/
" - 20 x 3" screw through the bottom of the
4
frame and out through the top of the rear bumper.
Assembly
13
Rear
Bumper
• From the top side of the frame, attach a
1
/
" - 20 lock nut to each screw.
4
• While holding the 3" screws steady with a Phillips screw-
driver, tighten the lock nuts with an adjustable wrench.
14
• Turn the frame upright.
• Fit the pretend motor to the top side of the rear bumper.
• Insert three #8 x
Do not over-tighten these screws.
11
Top View
1
/
Pretend
Motor
3
/
" into the pretend motor and tighten.
4
" washer and
4
Advertisement
Table of Contents
