Handle Assembly - Hoover 4600 Owner's Manual

1-2
C
D

Handle assembly

Place upper (B) and lower (C) handle sections on a flat surface
with cord hooks (A) on top. With hands on sides of handle sec-
tions, push sections together firmly until they "click" into place.
*Do not press against the rod (D) extending from the lower han-
dle. If the rod breaks or bends, the cleaner will not work prop-
erly. Do not push handle together with your hands on the ends
of the sections.
1-4
H
Rotate cord protector on
cord until you see its arrow
(H).
1-7
K
J
Note location of tapered rails (J) on
bracket (K) and on lower handle.
4
A
B
1-5
I
With arrow on cord protector pointing
toward arrow on upper handle, press
groove (I) in cord protector into slot in
upper handle.
Pull cord tight.
1-8
L
With printed side of bracket (K) facing
up, slide rails on bracket onto rails (J) on
lower handle until bracket snaps past
the lock tab (L).
1-3
"UP"
D
Attach cord
Note: The small red tab (E) above the ON/OFF switch (F) is for
shipping purposes only and may fall off during assembly. If it
does not fall off, the tab will be removed during the final steps of
assembly.
Turn handle over. Insert large rectangular end of cord into pocket
in bottom of handle, with side marked "UP" visible.
Make sure rectangular end is pushed into the handle as far as pos-
sible.
Slide cord protector (G) toward upper handle.
1-6
UP
Press cord into place at each of the three notches indicated and
note correct positioning of (G).
Do not plug cleaner in until assembly is totally complete.
J
K
G
1-9
M
Pull bracket toward bottom of handle
slightly to make sure bracket is locked
in place.
Make sure hole in bracket aligns with
hole in handle (M).
E
F
G