® Upright Vacuum Cleaner Thank you for your purchase! Owner’s Manual ENGLISH pp. 1-12 ESPAÑOL pág. 13-20 FRANÇAIS p. 22-28 Read this manual before operating cleaner www.hoover.com...
• Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot).
If you need any assistance: Visit our website at www.hoover.com. Click on the “Service” button to find the service outlet nearest you OR Call 1-800-944-9200 for an automated referral of service outlet locations (U.S. only) OR Call 1-330-499-9499 to speak with a representative in our Consumer Response Center.
Handle positions Transporting cleaner Carrying handle The handle of your cleaner has three posi- Put handle in upright position. Tilt Use the carrying handle to lift the tions; upright when using cleaning tools; cleaner back on rear wheels. Push cleaner. operating position for general operation forward.
2-11 Cleaning tools 2-12 Tools allow for cleaning surfaces above the floor and for reaching hard to clean areas. • The cleaner is ready for tool use when handle is in upright position. • For best tool performance, set the ON- OFF-HUSH™...
How to clean tools 3. Maintenance To clean the hose, wipe off dirt with a cloth dampened in a mild detergent. Familiarize yourself with these home When to empty Rinse with a damp cloth. maintenance tasks as proper use and It is recommended that the dirt cup be Cleaning tools may be washed in warm care of your cleaner will ensure contin-...
Using a screwdriver, remove the two Should you want to replace this filter, ask screws as shown and lift off lens. edge of dirt cup. for HOOVER part no. 38765024 (filter Replace lid and return cup to cleaner package part no. 40110004). (Fig. 3-4).
Excessive force is not required. 3-16 Belt replacement 3-17 The belt on your Hoover cleaner causes the agitator to rotate and is important for the effective operation of the cleaner. The belt is located under the hood of the cleaner and should be checked from time to time to be sure it is in good con- dition.
“Belt replacement” section to replace cated periodically by a Hoover Factory if brushes do not touch card. belt, new agitator, agitator cover and Service Center or an Authorized Hoover What to buy hood.
(U.S. only). • Agitator brush roll worn • Replace brush roll • Dirt cup full Do not send your cleaner to The Hoover • Empty cup Company in North Canton for service, this will only result in delay.
Check airflow path delivery, or house calls; however, if you 4. Remove hose end from cleaner. mail your appliance to a Hoover Factory 5. Plug cleaner in and turn ON. Check Service Center for warranty service, for suction at end of hose (B).