Advertisement
Cleaning the ProCrema filter holder
Do not place the ProCrema filter holder in
the dishwasher. Rinse the filter holder under
running water after each use.
l
Should the filter holder require a more
thorough cleaning, loosen the screw
located in the center of the filter holder
(see figure 301.
n
Slowly remove each part and gently rinse
by hand. Replace each part as shown on
figure 31.
General Cleaning:
n
After use, empty the water reservoir and
drip tray (see figure 27).
After preparing espresso approximately 10
times, the drip tray will need to be emptied
and cleaned in warm, soapy water.
n
Before replacing the drip tray and grid,
make sure the baffle has been
placed in the back of the drip tray
(see figure 28 + 29).
Do not try to disassemble the main body of
the machine!
The appliance should be descaled at regular
intervals taking into consideration the
hardness of the local water. For this
purpose, the brewing sieve and its sealing
ring MUST first be unscrewed from the
brewing head. In doing this, a valve spring
will also fall out. Remove lime and coffee
powder from the brewing sieve and the
brewing head.
The filter holder must NOT be inserted in
the brewing head. Pull the "Perfect Froth"
attachment off the steam / hot water nozzle.
Dissolve 4 tablespoons of tartaric or citric
acid (obtainable at chemists and drugstores)
in 34 ounces of lukewarm water and pour
the solution into the water container.
Place the largest convenient receptacle
beneath the brewing head and switch on the
appliance.
As soon as the red control lamp glows
continuously, press the B key. Repeat this
process three times. Then switch off the
appliance immediately and allow the
remainder of the solution to act internally
for lo-15 minutes.
Now switch the appliance on again and
repeat the entire process a further time.
Place a receptacle beneath the steam I hot
water nozzle and press the Q key. As soon
as the red control lamp glows continuously,
turn the steam knob to the @ position.
Allow the appliance to generate steam for
about 1 minute. Now return the knob to the
0
position and switch machine off for 10
minutes. Then switch the appliance on
again and repeat this process a further time.
After the steam generation, allow the
remainder of the descaling solution to run
through the brewing head be pressing
either the Cp or the m key.
After the completion of the descaling
operation, wash out the water container
thoroughly with clean water.
Place receptacle beneath the brewing head
and fill the water container with clean water.
Switch on the appliance. As soon as the red
control lamp glows continuously, press the
Sp key. Repeat this operation five times.
Now place a receptacle beneath the steam /
hot water nozzle and press the clr, key. As
soon as the red control lamp glows
continuously, turn the steam knob to the
@ position and let the appliance generate
steam for about a minute. Then return the
0
steam knob to the
off the appliance.
Insert the valve spring with the rubber seal
upwards. Relocate the brewing sieve and
seal in the brewing head.
Empty the drip tray and clean it.
Problem:
Coffee temperature too low.
Solution:
n
Place the cups on the warming plate of
the appliance to preheat.
position and switch
Advertisement
