Advertisement
Move the steam nozzle.
Wash all loose parts in warm soapy water,
rinse thoroughly and dry.
When using your KRUPS 'Novo 4000
Programatic" for the first time we
recommend running water through the
machine to remove any dust particles which
may have settled during shipping.
A Attention!
n Before you start, make sure that the cup
grid (i) is in place and the removable drip
tray (j) is properly inserted (figure 27).
Step 1
Before first use, we recommend allowing
water to run through the machine to cleanse
the internal system.
n Remove the water reservoir from the
machine by lifting up on the handle,
located on top of the water reservoir
(see figure 1).
W This allows you to conveniently bring the
water reservoir to the faucet. Fill with
cold water (see figure 2).
n Replace reservoir back into the machine
(see figure 3).
W The water level indicator will let you see
how much water remains in the
container, and you should refill as needed
(see figure 4).
n Insert the filter holder (without coffee)
into the machine and raise it up into the
brewing head at a 45 degree angle. Turn
the filter holder to the right until the
marking located on the auto-eject button
of the filter holder handle is within the
"lock-range" indicated on the lower edge
of the front panel. This will lock the filter
holder into place (see figure 5).
You are now ready to warm-up the
machine.
Step 2
n Place a cup that has at least a 5 oz.
capacity under the filter holder spout and
another cup or frothing pitcher under the
steam nozzle (see figure 6).
10
.
n
Turn the rotary dial to the 0 position
(see figure 7).
Press the ON/OFF button (c) (D
indicator light will flash, four LED lights
will be stationary green and the "memory
light" M will be orange (see figure 8).
When the red indicator light stops
flashing, the machine is ready for use
(see figure 9).
Press the automatic 'two" portion control
It
button m
will flash first, then begin to
run water through the system, dispensing
the hot water through the filter holder-
(see figure 10).
The portion control is pre-set into memory
and will dispense approximately 4 oz. of
water, then shut off automatically. You do
not need to manually stop or turn off the
system.
Repeat this process five times, each time
waiting for the red light to stop flashing.
This process will require you to stay with
the machine to empty each cup as it
becomes full.
n To clear the steam nozzle, press the hot
water button = and turn the rotary dial
to the 6 position. Place a cup or pitcher
under the nozzle (see figure 11).
Allow several ounces of water to run
through and then turn the rotary dial back to
the 0 position.
Note: Your machine has a thermostat that
controls the temperature continuously so
that it will be ready anytime you need it.
You may leave your machine on for several
hours using a minimum amount of power. If
you don't intend to use the machine for a
long period of time (overnight, for example),
it is recommended that you turn it off.
When using the appliance, you should pre-
warm the cups with hot water. Afterwards,
you can keep the cups at their ideal
temperature by placing them on top of the
warming tray upside down. You may also
want to place a dishcloth on top of the cups
to help keep them warm.
.
The red
Advertisement
