Advertisement
Pre-Warming Cups:
Turn the rotary dial to the 0 Position.
Insert the filter holder without coffee into
the machine.
Press the ON/OFF button (cl a
The red indicator light will flash, four LED
lights will be stationary green and the
"memory light" M will be orange.
When the red indicator light stops flashing,
the machine is ready for use. Place cup(s)
under the filter holder spout and press "one"
or "two" portion control button according to
the size of the cup(s). If the machine is ready
for use, the warming tray will slowly begin
to heat up. Place the cups upside down onto
the warming plate.
Step 1
n Fill the water reservoir with fresh cold
water (see figures l-31.
Step 2
n Turn the rotary dial to the 0 position
(see figure 7).
W Press the ON/OFF button (cl 0
indicator light will flash, four LED lights
will be stationary green and the "memory
light" M will be orange (see figure 8).
When the red indicator light stops flashing,
the machine is ready for use.
To prevent previous coffee particles from
clogging the brewing head, run a small
amount of water through the filter holder
(see Using for the first time) without coffee.
Hint: Leave the filter holder in the machine
without coffee and allow it to heat for
several minutes before brewing.
This, along with pre-warming the cups will
contribute to a hotter cup of espresso.
Step 3
n Remove the ProCrema filter holder from
the machine.
The filter holder selector ring can be
adjusted to three individual positions to
suit your personal taste (see figure 121:
R
4p,p 1 cup strong espresso
.
J@
Turn the selector ring to the desired
position.
l Depending on which setting you have
chosen add one, one and a half, or two
KRUPS measuring spoons of espresso
coffee (see figure 13).
m Make sure that you do not overfill the
basket. Press (tamp) the coffee lightly into
the filter holder using the back of your
KRUPS measuring spoon (see figure 14).
Your ProCrema filter holder also features a
built-in tamper, which will ensure that the
coffee has been evenly tamped.
n It is also vet-y important that you remove
any coffee that has fallen onto the rim of
the filter holder while you were filling or
tamping the coffee (see figure 151.
n Insert the filter holder into the machine
by raising it up at a 45 degree angle. Turn
the filter holder to the right until it is
firmly locked into place. The marking
located on the auto-eject button of the
.
The red
filter holder handle must be within the
"lock-range" indicated on the lower edge
of the front panel (see figure 181.
Place the warmed cup(s) under the filter
holder spout.
Step 4
The machine is already pre-programmed to
prepare either "one" (1.7 oz.) or "two' (4 oz.)
cups of espresso.
n Press the appropriate button for "one"
cp or "two" 12p (see figure 17).
The green light will begin to flash and the
appropriate amount of coffee will be
dispensend. Once brewed, the red indicator
light will begin to flash, indicating that the
machine is readjusting the brewing
temperature. However, this will not stop you
from continuing to brew espresso.
1 cup regular strength espresso
2 cups mild espresso
2 cups regular strength espresso
11
Advertisement
