Installation - Sharp AM-900 Service Manual

AM-900U

[4] Installation

1. Site selection
Take the following points into consideration when selecting a site for
this model.
ENVIRONMENT
• The machine must be installed on a level surface.
• Keep the machine away from air conditioners, heaters, direct sun-
light, and dust.
• Provide easy access to the front, back, and sides of the machine.
In particular, keep the area in front of the machine clear, or the orig-
inal document may jam as it comes out after scanning.
• The temperature should be between 50 - 86°F (10 - 30°C).
• The humidity should be between 20% and 85% (without conden-
sation).
ELECTRICITY
AC 120V, 60Hz, grounded AC (3-prong) outlet.
Caution!
• Connection to a power source other than that specified will cause
damage to the equipment and is not covered under the warranty.
• If your area experiences a high incidence of lightning or power
surges, we recommend that you install a surge protector for the
power and telephone lines. Surge protectors can be purchased at
most telephone specialty stores.
If the machine is moved from a cold to a warm place...
Condensation may form on the reading glass if machine is moved from
a cold to a warm place, this will prevent proper scanning of documents
for transmission. Turn on the power and wait approximately 2 hours
before using machine.
TELEPHONE JACK
A standard telephone jack must be located near the machine. This is
the telephone jack commonly used in most homes and offices.
• Plugging the fax machine into a jack which is not jack may result in
damage to the machine or your telephone system. If you do not
know what kind of jack you have, or need to have one installed,
contact the telephone company.
2. Attaching the trays
1) Attach the document feeder tray.
Slide the output tray into the machine as shown. When it stops, lift
the end slightly and push in so that the tray locks in place.
If you will be
using legal paper,
pull out the tray
extension.
Important: The output tray must be attached correctly or the
machine will not operate.
2) Releasing the scanner.
Before plugging in the power cord, pull the scanner release toward
you to release the scanner lock.
• Caution: Plugging in the power cord without releasing the scan-
ner lock may damage the machine.
• In the event that you need to move the machine, push the release
back in to lock the scanner before moving (push the release in after
you have unplugged the power cord).
3) Connecting the power cord.
Plug the power cord into a 120 V, 60 Hz, grounded AC (3-prong)
outlet.
• Caution: Make sure the scanner has been released as explained
on the previous page before plugging in the power cord.
• Do not plug the power cord into any other kind of outlet. This will
damage the machine and is not covered under the warranty.
• The machine does not have a power on/off switch. The power is
turned on and off by simply plugging in or unplugging the power
cord.
• If you area experiences a high incidence of lightning or power
surges, it is recommended that you install surge protectors for the
power and telephone lines. Surge protectors can be purchased
from your dealer or at most telephone specialty stores.
1 – 4