Sharp AM-900 Service Manual page 10

AM-900U
• In Windows 2000/XP ®
, if a warning message appears at any time
regarding the Windows logo test or digital signature, be sure to
click Continue Anyway or Yes.
6) When the Finish window appears to indicate that the selected
packages have been installed, click Close.
7) If the installation was a Standard installation, the following window
will appear. Click OK.
• If you installed the MFP drivers using a Custom installation and
did not install Sharpdesk, the following window will appear. Click
OK and go to Step 10.
8) The following window will appear. Click Yes to restart your com-
puter.
9) The Search Setup Wizard will appear. Follow the on-screen instruc-
tions to create an index database for Sharpdesk.
10)Make sure that the power cord of the machine is not plugged in
(the machine is powered off), and then connect the USB cable.
• Insert one end of the USB cable into the USB port on the machine
and the other end into your computer's USB port.
Note: Do not connect the AM-900 to a hub to which another AM-
900 is connected. If this is done, the AM-900 will not operate cor-
rectly.
11)Plug in the power cord of the machine.
• Windows XP ®
: Go to the procedure for completing installation of
the software.
®
• Windows 2000
: This completes the installation of the software.
Note: If a warning message regarding the Windows logo test
appears (the warning may appear twice), click Yes each time the
window appears. This will complete the installation of the software.
®
• Windows Me
/98SE
ware.
Completing installation of the software on Windows XP®
(Continued from Steps 10 and 11.)
1 – 8
®
: This completes the installation of the soft-