Honeywell ULTRAKEY LITE HJC5000 Installation And User Manual page 66

System Administration and Troubleshooting
Adjusting the Back Light
Updating the Touch Pad Firmware
Viewing the Firmware Version
66
1. Log into the controller.
2. From the System Set: Config menu, press the LCD
up/down arrow keys to scroll to Back Light. Press Ent.
3. Use the LCD up and down arrow keys or the rotate the
touch pad to adjust the back light intensity.
Slider firmware should be updated whenever a new slider firmware version is released.
Check regularly to make sure that you are using the most up-to-date slider firmware.
Note Slider firmware can be downloaded using the web browser. See
the UltraKey Lite Firmware
procedure on
the update. Use the following procedure to update the slider firmware after
downloading the firmware file.
1. Log into the controller.
2. From the System Set: Config menu, press the LCD up/down arrow keys to scroll to
Slider Update. Press Ent.
The message Update Confirm? displays.
3.
4. Press the LCD up arrow key to select Yes or No.
• Select Yes and press Ent to upgrade the firmware.
• Select No and press Ent to cancel.
If you select Yes, the message Slider Firmware: Download displays, followed
5.
by Download: OK.
6. Press Ent to exit the menu.
1. Log into the controller.
2. From the System Set: Config menu, press the LCD up/down arrow keys to scroll to
About. Press Ent.
The LCD scrolls to display the firmware version.
3. Press any key to return to the previous menu.
on page 68 to download the firmware. Using the
page 68 will download the slider firmware file, but will not apply
Configuration
Back Light
Upgrading