Figure 3-11 Serial Port Configuration Tab; Figure 3-12 Ip Configuration Tab - Honeywell ULTRAKEY LITE HJC5000 Installation And User Manual

Installing UltraKey Lite with VideoBloX
Step 3B: Configure the Controller for an Ethernet Connection
44
2. Under Serial Port1 Settings, select the following from each drop-down list as
required:
• Baud Rate: 1200, 9600, 19200 or 57600 bps.
The default for VideoBloX is 19200.
• Parity: none
• Stop Bits: 1 bit
• Data Bits: 8 bits
• Serial Mode: RS422
3. Click Apply to save the configuration, Cancel to exit without saving, or Default to
restore all factory default values.
Figure 3-11 Serial Port Configuration Tab
1. From the side menu, click IP Configuration. See
2. In each of the fields, enter IP address, subnet mask, gateway and DNS values.
3. Click Apply to save the configuration, Cancel to exit without saving, or Default to
restore all factory default values.
Figure 3-12 IP Configuration Tab
Figure 3-12.