Installing And Configuring An Ethernet Connection - Honeywell ULTRAKEY LITE HJC5000 Installation And User Manual

Installing UltraKey Lite with VideoBloX
Step 4: Configure VideoBloX Mode Default Settings While Powering Up

Installing and Configuring an Ethernet Connection

Step 1: Connect to the UltraKey Lite Ethernet Port
36
Note In this field, you are setting the VideoBloX NetCPU IP address. To set the
UltraKey Lite IP address or enter the main configuration menus, press Alt >
Clr and see Step 3: Set and Configure for an Ethernet Connection
16. Use the numeric keypad to enter an IP address as required,
then press Ent.
1. While powering up, when the Time Left 3 menu displays, press Alt > Camera to set
the VideoBlox mode.
2. Set the corresponding serial port as:
Baud Rate: 19.2 KB
Data Bit: 8
Parity: None
Stop Bit: 1
For a list of accessories see
pin assignments see UltraKey Lite Port Connections and Descriptions
UltraKey Lite Controller runs TCP/IP keyboard protocol.
Note The direct RJ45 connection using the Ethernet port is only available with
newer model VideoBloX NetCPU systems.
Shipping Checklist on page
on page
IP Address
159.099.251.230
Time Left 3
18 and for port connections and
on page 19. The
.
38