Assembly And Installation Of Rear Pto - Cub Cadet 7530 Maintenance Manual

5
5.5

Assembly and Installation of Rear PTO

1. Clean each part and assemble.
2. Make sure that snap rings and spring pins are securely assembled.
3. Apply oil to the O-ring and needle bearing for assembly.
4. Apply lithium grease to the oil seal for assembly.
5. Assemble as shown in the drawing for the spur gears with specified mounting direction (edgy or chamfered
side).
Liner "A"
Liner "A"
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Transmission
MID PTO change
19T
Parts measurement 160.3 +0.4
0
Component measurement 160.08
0.02-0.86
Clearance
33T
46T
Rear PTO change
6. Adjust the endplay shown in the drawing to be
within 0.05 to 0.20mm {0.002 to 0.008in} with
liner "A".
Liner "A"
Note) * use only for HST specification.
GZ3W24-036
71
PTO drive shaft
10T
+0.2
-0.24
Liner "B"
Oil
Parts measurement 61.5
Component measurement 61.5
Clearance 0.25-1.02
Grease
44T
Liner "C"
Item Thickness
0.15 {0.006}
0.2 {0.008}
0.4 {0.016}
1.0 {0.039}
Rear PTO shaft
+0.4
+0.3
+0.05
+0.62
GZ3W24-035
(Unit: mm {in})
Parts No.
0731 0002 001*
0731 0002 002*
0731 0002 004*
0731 0002 010