Inspection And Maintenance Of Steering - Cub Cadet 7530 Maintenance Manual

2. Relieve for approximately 3 seconds on the maximum steering angle by operating the steering wheel to left and
right.
3. Repeat the procedure 2 in both left and right direction 3 to 4 times.
Forward
B
A
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Steering
8.4
8.4.1
Toe in functions as an important role to control the
stability of the vehicle. Tendency for control loss of
vehicle while running may be caused by misalignment of
toe in. In such case, inspect and adjust.
• Adjust the both sides of tie rod end at the same
GS7W3-195
• Make sure the nonexistence of looseness for
121
Inspection and Maintenance
of Steering
Inspection and Maintenance of Toe In
Item
Toe In (A - B)
CAUTION
time.
front tire while adjusting.
1) Loosen the locknut for tie rod end.
2) Remove the nut for tie rod end from the knuckle
arm.
3) Adjust the length of tie rod end by turning only
the tie rod end.
4) Tighten the locknut after adjusting.
Torque: 147 to 167N•m {1500 to
1700kgf•cm, 108 to 123lbf•ft}
8
(Unit: mm {in})
Referential Value
0 to 10.0 {0 to 0.39}