Table of Contents
Advertisement
T
ROUBLESHOOTING
The following guide is for reference purposes only. Contact a customer service
representative to preserve the limited warranty terms on page 39.
Symptoms
All Interfaces
During power
up the unit
beeps three
times.
During power
up the unit
razzes once
and the blue
LED flashes.
During power
up the unit
razzes twice
and both LEDs
flash in unison.
The unit has no
LEDs, beeper
or motor spin.
The unit has no
LEDs and / or
beeper.
The unit powers
up but does not
beep.
G
UIDE
Possible Cause(s)
There is a non-volatile
RAM failure.
There is a VLD failure.
There is a scanner
motor failure.
No power is being
supplied to the
scanner.
The unit may be in
power save mode.
No power is being
supplied to the
scanner from host.
The unit may be in
power save mode.
The beeper is disabled.
No tone is selected.
Solution
Contact a customer service
representative.
Check the transformer, outlet
and power strip. Make sure the
cable is plugged into the
scanner.
Push the button to "wake" the
unit.
Some host systems cannot
supply enough current to power
the OrbitCG. Use the power
supply included with the
scanner.
Push the button to "wake" the
unit.
Enable the beeper.
Select a tone.
23
Hide quick links:
Advertisement
Table of Contents
