Table of Contents
Advertisement
I
NSTALLATION
Stand-Alone Keyboard
1.
Turn off the host device.
2.
Plug the male 10-pin RJ45 end
of the PowerLink cable into the
10-pin socket on the MS7180.
3.
Connect the other end of the
PowerLink cable to the keyboard
port on the host device.
4.
Plug the external power supply into
the power jack on the PowerLink
cable.
Check the AC input
requirements of the power
supply to make sure the
voltage matches the AC
outlet. The outlet must be
located near the equipment
and be easily accessible.
5.
Connect AC power to the transformer.
6.
Turn on the host device.
When the scanner first receives power, the blue and white LED will
toggle on and off then the scanner will beep once.
Powering the MS7180 directly from the host device can sometimes
cause interference with the operation of the scanner or the computer.
Not all computers supply the same current through the keyboard port.
For this reason, Honeywell recommends using an external power
supply. For additional information contact a customer service
representative.
See page 5.
10
Figure 12.
Hide quick links:
Advertisement
Table of Contents
