Barcode Configuration Guide; Barcode Configuration Methods - Honeywell HF680 User Manual

Barcode Configuration Guide

Your new scanner has been configured at the factory with a set of default communication protocol. Since many host systems have
unique formats and protocol requirements, Honeywell provides a wide range of configurable features that may be selected with
the use of this barcode configuration guide.
Once the configuration is completed, the scanner stores the settings into the Flash and the settings won't lose when the power is
turned off.

Barcode Configuration Methods

This scanner can be barcode configured in two ways: the Single-Code Method and the Multi-Code Method.
Single-Code Method
Most features can be enabled or disabled using the Single-Code Method.
1. Power up the scanner.
2. Scan the barcode(s) for the desired feature(s).
3. Observe a multi-tones, "save setting" beep that indicates the configuration has been saved.
Multi-Code Method
All features can be enabled or disabled using the Multi-Code Method.
A features marked with a "~" requires the Multi-Code Method.
1. Power up the scanner.
2. Scan the Enter/Exit Configuration Mode barcode. [3 beeps]
3. Scan the barcode(s) for the desired feature(s). [1 beep]
4. Scan the Enter/Exit Configuration Mode barcode [3 beeps] and save new configuration.
Note: To abort a configuration change, power off the scanner before scanning the Enter/Exit Configuration Mode
barcode.
* (asterisk) Default Feature
~ (tilde) Feature requires the Multi-Code Configuration Method,
See section "Barcode Configuration Method".
Enter/Exit Configuration Mode
Symbol Key
1 – 5