Error Code Table; Dvs-7600 Error Code; Touch Being Input; Serial Writing Screen - Kenwood DDX6019 Service Manual

Error code table

DVS-7600 error code

Code Error description
00 NO ERROR
03 DVD-Video REGION CODE ERROR
13 DVD-Video PARENTAL LEVEL ERROR
23 DVD DESCRAMBLE FAILED
04 READ ERROR
05 UNKNOWN DISC
15 UNKNOWN CD
25 UNKNOWN DVD
07 ROM ACCESS ERROR
17 RAM ACCESS ERROR
27 SDRAM ACCESS ERROR
37 MPEG DECODER ACCESS ERROR
47 ATAPI ASIC ACCESS ERROR
57 AUDIO D/A CONVERTOR ACCESS ERROR
67 FRONT-END COMMUNICATION ERROR
77 DRIVER ACCESS ERROR
09 MEDIA LOAD FAILED
19 MEDIA EJECT FAILED
29 REGION CODE SETUP FAILED
39 MECHA SETUP FAILED
99 MECHA ERROR
0D HOT ERROR
XX others (Reserved)

Serial writing screen

• Write in the serial code for each set.
Serial No. input screen
1
4
7
Clear Cancel
Key specification
0~9: 10 Key for entering serial No.
Clear: Clear the serial No. being input.
Cancel: Move on to Service screen.
TEST MODE
– – – – – – – –
2 3
5 6
8 9
0
DDX6019/6029/6029Y/6039
Writing screen for after entering the serial No.
Clear Cancel
Key specification
Clear: Clear the serial No. being input.
Cancel: Move on to Service screen.
Enter: Start serial No. writing (normal completion with "Write
OK" displayed, error with "Write NG" displayed).
If OK, press this key to move on to the Service screen.
If NG, go into the test mode again and repeat from the 1st
step.
Touch screen
• Fine-adjust the fluctuation of Touch of each set.
Touch the 3 markers, and completed if the EEPROM OK
screen is displayed.

Touch being input

1st point is being input
Cancel
3rd point is being input
Key specification
Cancel:
1st point being input; Move on to Test Mode Main screen.
2nd point and thereafter being input; Move on while the 1st
point is being input.
Enter
2nd point is being input
25