Chroma Auto1 Screen; Source/Set Up/Audio Screen; Securitycode Writing Screen; Tuner Span Switching - Kenwood DDX6019 Service Manual

MECHA Adjust completed
MECHA Adjust
Mecha Adjust OK/NG
Note: If NG, check and make sure that the mechanism po-
sition adjustment jig is properly installed, and go into the
test mode again and repeat from the 1st step.

Chroma Auto1 Screen

• Automatically adjust Chroma data.
• At the same time as moving on to the Chroma AUTO screen,
automatic adjustment is started.
Auto Set OK
Return
Key specification (remote control)
Return: Move on to Test Mode Main screen.
Next: [Invalid] key (not used)
Chroma Func screen
• Adjust Chroma data.
• Adjustment is done using the remote control (AudioSW) (re-
fer to the separate sheet for more detail).
• There are 2 types of items to be adjusted: TINT and Phase.
Note: EEPROM chroma data can be cleared by the Clear
key on the Service screen.
T I N T
V A L
TEST MODE
1
Return
Next
DDX6019/6029/6029Y/6039
Key specification (remote control)
Direct: Chroma_IC adjustment mode ON/OFF (writing-in
EEPROM)
Play/Pause: Setup/cancel Chroma setting value
Tenkey 7: Chroma adjustment item change
Tenkey 8: Change the Chroma setup value (UP)
Tenkey 9: Chroma adjustment item change
Tenkey 0: Change the Chroma setup value (DW)

Source/Set Up/Audio screen

• Same as in the normal screen (other than in Test Mode),
but if the [SetUp] key and the [Audio] key are pressed, the
screen goes back to the Test Mode Main screen.

SecurityCode writing screen

• Writes in the SecurityCode managed in combination with
the serial (other than K/R destination).
• From the SetUp screen, press the [Security Set Up] key.
• On other than K/R destination, when EEPROM's Security
Code is blank, the [Set] key is displayed. Press the [Set]
key.
• In the Security Code writing-in screen, run the same opera-
tion as when registering Security Code in normal mode,
and press the [Enter] key to start writing.
Note: The Security Code to be entered here is the set-spe-
cific code linked to the serial No.
• If "Complete" is displayed, normally completed, and if "NG"
is displayed, ended with error.
Note: If NG, go into the test mode again and repeat from
the 1st step.
Tuner Span switching (K
• Press and hold [SRC] key + [Vol Dw] key and Reset (or
Back Up On) to switch between the Tuner spans K
• Span information can be checked on the test mode Infor-
mation screen. (For destination whose Span cannot be
switched, "–" is displayed.)
M switching)
M.
27