Installing A Dimm - HP ProLiant BL460c G6 User Manual

•
DIMM configuration on channel 1 and channel 2 of a processor must be identical.
•
In multi-processor configurations, each processor must have a valid Lockstep Memory configuration.
•
In multi-processor configurations, each processor may have a different valid Lockstep Memory
configuration.
Single-processor Lockstep population order
For Lockstep memory mode configurations with a single processor, populate the DIMM slots in the following
order:
•
RDIMM
First: A and B
o
Next: D and E
o
Do not populate slots C or F.
o
•
UDIMM
First: A and B
o
Last: D and E
o
Do not populate slots C or F.
o
After installing the DIMMs, use RBSU to configure the system for Lockstep memory support
lockstep memory" on page 57).
Multi-processor Lockstep population order
For Lockstep memory mode configurations with multiple processors, populate the DIMM slots for each
processor in the following order:
•
RDIMM
First: A and B
o
Next: D and E
o
Do not populate slots C or F.
o
•
UDIMM
First: A and B
o
Last: D and E
o
Do not populate slots C or F.
o
After installing the DIMMs, use RBSU to configure the system for Lockstep memory support
lockstep memory" on page 57).

Installing a DIMM

CAUTION:
baffle, drive blanks, and access panel must be installed when the server is powered up.
Power down the server
1.
Remove the server blade (on page 13).
2.
Remove the access panel (on page 14).
3.
To avoid damage to the hard drives, memory, and other system components, the air
("Power down the server blade" on page 12).
Hardware options installation 33
("Configuring
("Configuring