Disassembly - Pioneer XV-HTD530 Service Manual

5

7.1.13 DISASSEMBLY

DIAGNOSIS OF PCBs
Note: For performing the diagnosis shown below, the following jig cables for service are required:
• GGD1228
• GGD1222
• GGD1315 (×2)
1
Bonnet and Tray Cap
1
Remove the bonnet by removing the eleven screws.
2
Press the STANDBY/ON button to turn on the power.
3
Press the 0 OPEN/CLOSE button to open the tray.
4
Remove the tray cap.
5 Press the 0 OPEN/CLOSE button to close the tray.
6
Press the STANDBY/ON button to turn off the power.
2 6
4
3
5
Tray Cap
Note when reattaching the bonnet
When reattaching the bonnet, to avoid damaging the unit, hook
the bonnet by supporting and lightly pushing it upward by hand
from the rear, as shown in the photo below.
Bonnet
Hook
5
6
How to open the Tray when the power cannot
be on
1
Remove the two screws.
2
Create a little gap between the main unit and the Table
Mechanism Section by holding and pulling up the rear side
of the Table Mechanism Section by hand.
3 5
3
Insert your hand through the gap below the Table
Mechanism Section.
4
Turn the gear pulley counterclockwise as viewed from the
top.
5
If the tray pops out a little, fully pull it out by a hand.
Table Mechanism Section
XV-HTD530
6
7
1
Rear Panel
2
4
5
Gear Pulley
Bottom View
7
8
A
B
1
C
D
Gear Pulley
3
E
4
F
117
8