Pioneer XV-HTD530 Service Manual page 124

1
9
Open the tray by turning the gear pulley counterclockwise viewed from the top.
(After the tray pops out a little, fully pull it out by hand.)
A
10
Disconnect the flexible cable.
11
Remove the Table Mechanism Section by unhooking at the two points.
B
Table Mechanism Section
C
If the Table Mechanism Section cannot be removed
Displacement of the rotary tray may be the cause. (If this is the case, in Step - above, the two hooks cannot be seen,
because they are covered by the rotary tray.)
In this case, set the rotary tray in the correct position, following the steps below.
D
E
2
Adjust the position of the rotary tray
so that the center hole can be seen.
F
124
1
2
11
Rotary Tray
2
3
10
9
11
1
Remove.
3
Tighten.
Note:
It is not necessary to set the Disc No. of the rotary tray,
because the Automatic Disc No. Detection system will function.
XV-HTD530
3
4
11
9
Gear Pulley
Bottom View
4