Removing And Installing Modular Devices - Fujitsu LifeBook T901 Series User Manual

Lock CD/DVD drive when the unit is in tablet
mode:
This checkbox should normally be checked (see
"Important Notes" above). If you would like to
access the CD/DVD drive while your system is
in undocked tablet mode, deselect this checkbox.
A message will appear asking if you really want
to unlock the drive. Click [OK] to proceed, or
[Cancel] to return to the utility.
Show tray icon when CD/DVD drive is
locked:
This checkbox should normally be checked. If
you would not like the Fujitsu Tablet Controls
icon to appear in the system tray when the drive
is locked, clear this box.
Show notifi cation messages when CD/DVD
drive is locked/unlocked:
This checkbox should normally be checked. If you
would not like to be prompted when the drive is
locked or unlocked, clear this box.
Buttons
• Click the [OK] button to accept the changes
and close the window.
• Click the [Apply] button to accept the changes
and leave the window open.
• Click the [Cancel] button to close the window
without accepting the change.
• Click the [Help] button to view the help fi le
associated with the selected tab within Fujitsu
Tablet Controls.
System Tray Icon
When your system is in undocked tablet mode,
and the "Lock CD/DVD drive when the unit is
in tablet mode" box is checked, a Fujitsu Tablet
Controls icon will appear at the bottom right of
the display. When you select this icon, a menu
will appear containing three items:
• Lock CD/DVD drive when the unit is in tablet
mode.
• Show tray icon when CD/DVD drive is
locked.
• Show notifi cation messages when CD/DVD
drive is locked/unlocked.
64
Unlock CD/DVD Drive for this tablet session
When you click this menu item, you will be
asked whether you really want to unlock the
drive. To unlock the drive, click [Yes]. Note that
enabling the drive in this manner will not change
the setting in the Fujitsu Tablet Controls control
panel applet.
Confi gure
When you click this menu item, the Fujitsu Tablet
Controls window appears.
About
When you click About, the help fi le will open.
Removing and Installing Modular
Devices
There are two ways to remove and install modular
devices in the Modular Bay:
• Cold-swapping: swapping devices while your
Tablet PC is powered off.
• Hot-swapping: swapping devices while your
system is active using the Unplug/Eject icon
from your taskbar. Note that if the weight saver
is installed rather than a modular device, it
is not necessary to use BayManager when
removing it.
You should never leave your Modular Bay
empty when the tablet is in operation. If left
empty, dust or foreign matter may accumulate
inside the tablet.
Cold-swapping
To cold-swap modular devices in your Modular
Bay follow these easy steps: (Figure 4-7)
1. Close any open fi les.
2. Shut down your Tablet PC.
3. Pull out the Modular Bay eject lever. This will
push your device out slightly, allowing you to
remove it.