Speaker; Muting; Ringback When Busy (Ccbs)/When The Call Is Not Answered (Ccnr) - Gigaset CX610 ISDN Manual

Making calls
Is your telephone connected via a
PABX/gateway?
You can establish this by checking for an
additional device connected between your
telephone and house connection, e.g., a
PABX, gateway etc. In most cases, simply
resetting this device will remedy the situa-
tion:
¤ Briefly disconnect the mains plug of your
PABX. Re-insert the plug and wait for the
device to restart.
If the caller number is still not
displayed:
¤ Check the CLIP settings of your PABX and
activate this function if necessary. In the
user guide for the device, search for the
term "CLIP" (or an alternative term such
as "calling line identification", "phone
number transmission", "caller ID", ...).
If necessary, contact the device manufac-
turer.
If this does not resolve the problem, it is pos-
sible that your network provider does not
the CLIP service for this number.
Have you ordered the calling line
display service from your network
provider?
¤ Check whether your provider supports
calling line display (CLIP) and that the
function has been activated for you. If
necessary, contact your provider.
Additional information on this subject can
be found on the Gigaset homepage at:
www.gigaset.com/service

Speaker

In speaker mode, instead of holding the
handset to your ear you can put it down, for
example on the table in front of you. This
allows others to participate in the call.
36
Activating/deactivating speaker
mode
Activating while dialling
~ d
Enter the number and press the
speaker key.
¤ Inform your caller before you use the
speaker function so that they know a
third party may be listening.
Switching between earpiece and
speaker mode
d
Press the speaker key.
During a call , activate or deactivate speaker
mode.
If you wish to place the handset in the base/
charger during a call:
¤ Press and hold the speaker key d while
placing the handset in the base/charger
and for a further 2 seconds.
For instructions on adjusting the speaker
volume, see ¢ page 61.

Muting

You can deactivate the microphone in your
handset during an external call.
h
Press the key to mute the hand-
set. The display shows Micro-
phone is off.
Press the key again to unmute
the microphone.
Please note
If the telephone is muted, only the mute
key h and the end call key a will
work.
Ringback when busy (CCBS)/
when the call is not answered
(CCNR)
If the person you are calling does not answer
or their line is busy, you can initiate ringback.