Installing The Keyboard - Gateway M405 Hardware Replacement Manual

Installing the keyboard

To install the keyboard:
1
Place the new keyboard keys-down on your notebook with the space bar
away from you.
2
Pull up on the keyboard connector, located near the middle of the system
board, to verify the connector is in the raised position.
3
Slide the end of the keyboard cable into the keyboard connector.
Important
4
Press down on the keyboard connector using two fingers. This locks the
keyboard cable into the keyboard connector.
5
Rotate the keyboard toward the LCD panel until the keyboard is
almost face-up.
The keyboard cable should slide easily into the keyboard
connector. The cable is correctly oriented if it is not twisted.
www.gateway.com 7