Rosen Multimedia Navigation System Owner's Manual page 139

Use Caution around SRS Components
It is the installer's responsibility to ensure that the safety
equipment in the vehicle is NOT adversely affected by installation
of this system. Ensure that the routing of the harnesses do NOT
obstruct airbags, SRS or other safety devices.
Mount the GPS and Sat Radio antenna in a
location on the exterior of the Vehicle
Route the GPS harness away from other power harnesses in the
vehicle and locate the Antenna 12" away from the radio.
If the Antenna is Dash Mounted, it MUST be attached to a metal
plate 3"x3" to ensure acceptable GPS performance
Install the iPod interface connector in a
location accessible to the end-user
Locate the iPod interface module in an area which can be
serviced in the future.
The iPod cable is intended to be a serviceable item, which plugs
into the iPod/Sat radio Interface Module.
Remove the DVD Transport Screws
There are 2 x Phillips Transport Screws which protect the DVD
Mechanism during transportation.
Transport Screws must be removed prior to installation.
Rosen Entertainment Systems
Multi-Media Navigation System Installation Guide
Installation Guide
GM
Series
Copyright 2010 All Rights Reserved
DP-GM1014 Rev A
Page 6