Rosen Multimedia Navigation System Owner's Manual page 128

1\fap
The software works with digital maps which are not simply the computerized versions of traditional paper
maps. Similarly to the paper road maps, the 20 mode of digital maps show you streets, roads, and
elevation is also shown by colors.
In 3D mode, you can see the altitude differences, for example valleys and mountains, elevated roads, and
in selected cities 3D landmarks and 3D buildings are also displayed.
You can use digital maps interactively: you can zoom in and out (increase or decrease the scale), you
can tilt them up and down, and rotate them left and right. In GPS-supported navigation, digital maps
facilitate route planning.
North-uJl map orientation
In North-up mode the map is rotated so its top always faces North. This is the orientation for example in
Find on Map. See also Track-up map orientation.
Road Safety Came,"a
Special alert points for speed, red light or bus lane cameras. Different data sources are available. You
can configure the software to warn you when you approach one of these cameras.
Detecting the location of Road Safety Cameras is prohibited in certain countries. It is the sole
responsibility of the driver to check whether this feature can be used during the trip.
The software is capable of showing and warning for more than just cameras. Various other types of
proximity alert points like school zones and railroad crossings are also available.
Route
A sequence of route events, Le. maneuvers (for example, turns and traffic circles) to reach the
destination. The route contains one start point and one or more destinations. The start point is the current
(or last known) position by default. If you need to see a future route, the start point can be replaced with
any other given point.
Track-Up map orientation
In Track-up mode the map is rotated so its top always points in the current driving direction. This is the
default orientation in 3D map view mode. See also: North-up map orientation.
Vehimarker
The current position is shown with a red arrow on the map by default. The direction of the red arrow
shows the current heading. This position marker can be replaced with different vehicle and pedestrian
symbols. You can even specify different Vehimarkers for different route types (depending on which
vehicle type is selected for route calculation).
63