Honeywell MAGICSTAT CT3300 Installation And Programming Instructions page 13

Program period
WAKE
LEAVE
RETURN
SLEEP
Programming tips
• You do not need to program times and temperatures for all program periods.
If you decide not to program your thermostat, it will automatically control heating at 68 F (20 C) and cooling at 78 F
(26 C), 24 hours a day.
If you decide not to program weekend schedules, the temperature that is programmed for the weekday SLEEP
schedule will remain in effect until the next program period, which begins on Monday morning.
• The temperatures cannot be set any higher than 88 F (31 C) or any lower than 45 F (7 C).
• When pressing the buttons, use the ball of your finger or a soft pencil eraser. Use of sharp fingernails or pencil points
can damage the keypad.
• If you make an error at any time during programming, press
the program period where you left off.
69-0654-5
Description
The time when you get up and get ready to leave your home.
You can set the system at a comfortable temperature for this
period.
The time when you are regularly away from home. You can set
an energy-saving temperature for this period.
The time between returning home and going to bed. You can
set the system at a comfortable temperature for this period.
The time when you are sleeping. You can set an energy-saving
temperature for this period.
When available
Weekdays and weekend
Weekdays only
Weekdays only
Weekdays and weekend
. Then press or until you reach
13
PROGRAMMING