installing your dryer
DOOR REVERSAL
Depending on your requirements (installation location, space constraints), you can change the direction the
door opens.
This is done according to the customer's needs. The qualifi ed technician or customer can do this
themselves directly.
WARNING
1. Unplug the power cord.
2. Remove the two screws from the door-hinge.
3. Lift the door to separate it.
4. Remove the 16 screws.
5. After removing the screw, rotate the holder-glass, the door-glass, and the
cover-door (I) by 180˚ as shown in the fi gure.
•
Since the holder-glass, the door-glass, and the cover-door (I) are not
completely fi xed, rotate them holding the lower part so that they are
CAUTION
not separated.
•
Work carefully so that the door-seal is not removed.
6. After rotating them by 180˚, hold them in the position as shown by the
fi gure.
7. Assemble the glass-holder in the correct direction. (After the
disassembly, assemble it by rotating it by 180˚.)
16_ installing your dryer
Frame-Front
Assy-Door
Hinge-Door
Door-Glass
Holder-Glass
Seal-Door
Cover-Door(I)