3.0 Service Adjustments
Contents
3.1 Introduction ...................................................................................................3-1
Arc Lamp Alignment ....................................................................................3-7
3.3 ILA® Back Focus..........................................................................................3-9
3.5 ILA® Overlap ...............................................................................................3-12
3.8 Software Updating.........................................................................................3-17
3.1 Introduction
This chapter details adjustment procedures required to maintain the Model 100.
Refer to Figure 3-1 and Figure 3-2 to locate assemblies and components. A tool list,
required to perform adjustments, is in Chapter 1.
review the chapter on Safety at the beginning of this manual.
WARNING!!!
that require projector covers to be off, wear high voltage gloves
(ANSI/ASTM 10,000 volt rated) when working near the CRTs, Arc
Lamp, or power supplies. Wear safety goggles (rated X5) when
working anywhere near the light path from the arc lamp or the
projection lens.
Model 100 Service Manual
CAUTION!
Before performing procedures in this chapter,
When performing procedures in this chapter
Chapter 3---Service Adjustments
3-1