Safety Information - Hughes JVC 100 Service Manual

Hughes jvc 100 projector service manual
Hide thumbs Also See for 100:
Table of Contents

Advertisement

Safety Information

Introduction
Read entire Safety Chapter thoroughly before performing any maintenance or
service on the projector. Only qualified service personnel should perform
procedures and adjustments.
Safety Equipment: Use safety equipment specified in the projector's
maintenance training and certification program.
Warnings and Cautions!
Warnings and Cautions in this manual should be read thoroughly and strictly
adhered to. Warning and Caution definitions and symbols are as follows:
potential electric shock hazard in a procedure or situation that could
result in personal injury if improperly performed.
safety hazard or potential light hazard from ultraviolet, infrared or
bright light that could cause severe eye injury or a situation that could
result in damage to the equipment if improperly used.
Installation Safeguards
require removing the projector's covers to access internal component
to remove, replace, service and adjust the projector. Only Hughes-
JVC Certified Technicians are qualified to perform these procedures.
Before removing or replacing any internal components or
subassemblies, verify that the circuit breaker on the back panel is in
the Off position and remove the power plug. Any adjustments
Model 100 Service Manual
WARNING SYMBOL!!!
CAUTION SYMBOL!
WARNING!!!
Procedures in this service manual
Safety Information
Warns user of a
Warns user of a potential
v

Advertisement

Table of Contents
loading

Table of Contents