Crt/Ila; Assembly - Hughes JVC 100 Service Manual

Chapter 4---Maintenance (Removal/Replacement)
8. Remove the white standoff retainer from in front of the PCB.
9. Slide the Video Amplifier PCB out.
10. Replace the PCB in the reverse order.
Figure 4-14 Video Amplifier PCB for Red CRT.
11. Green and Blue Video Amps are turned around 180 .
4.17 CRT/ ILA
In the Model 100 the CRT and ILA
as one part.
NOTE: The CRTand ILA
optic on its output.The ILA
are separated by a thin film of optical fluid. Disassembly of the CRT/ILA
Assembly should not be attempted except by Hughes-JVC trained technicians in a
clean room environment.
WARNING!!!
with extreme caution. If dropped, they can implode and flying glass can
cause severe injury to personnel. Be careful not to bump or drop the CRT.
Place in a safe area immediately after removal.
The CRT/ILA
Red CRT/ILA
®

CRT/ILA

assemblies
To remove a CRT/ILA
1. Remove all the covers. (Section 4.2).
Model 100 Service Manual
®

Assembly

®
should be treated as one unit. The CRT has a fiber
®
also has a fiber optic on its input. These fiber optics
The CRT/ILA
®
Assemblies are located in the main body of the projector. The
®
assembly is turned perpendicular to the Green and Blue
®
Assembly (see Figure 4-15):
CN106
®
are removed from the projector and replaced
®
Assemblies should be handled
Heat
CN101
Sink
BNC
CN108
CN107
CN102
CN103
CN109
CN105
Standoff
®